LNB Inverto Multiconnect Dielectric Quad 23mm
KSh6,026.00
This innovative LNB was specifically designed for installations that make use of several LNBs on a satellite dish antenna. Its novel slim feed technology incorporates advanced dielectric materials and a perfect front end design. This technology ensures maximum energy transfer from the dish to the LNB circuits also when the LNB position is off the focal point. Furthermore, its long neck allows placing the LNBs closely next to each other and gain access to satellites typically too close in their orbital positions to be received with standard neck LNBs on a standard satellite dish antenna. The LNB enables the reception of signals from one satellite and its distribution to maximum four Set Top Boxes with Single Tuner (or two STBs with Twin Tuner).?
Features
Novel Slim Feed Technology
Low Phase Noise, DVB-S2 (HDTV) compliant
Low Noise Figure
Low Power Consumption
High Cross Polarization Isolation High Frequency Stability
Specifications
Inverto IDLB-QUDL24-MULTI-OPP
Low Band Input Frequency Range 10.7 ~ 11.7 GHz
Low Band Output Frequency Range 950 ~ 1950 MHz
Low Band LO Frequency 9.75 GHz
High Band Input Frequency Range 11.7 ~ 12.75 GHz
High Band Output Frequency Range 1100 ~ 2150 MHz
High Band LO Frequency 10.6 GHz
Noise Figure 0.2 dB Typ. (0.7 dB Max.)
LO Initial Accuracy +/- 1.0 MHz Max.
LO Temperature Drift +/- 3.0 MHz Max.
Phase Noise (@ 10 kHz) – 90 dBc / Hz Max.
Conversion Gain 60 dB Min.
Gain Ripple (Over 26 MHz Bandwidth) +/- 0.75 dB
Gain Variation (Over Full Band) +/- 4 dB Max.
Image Rejection 40 dB Min.
1 dB Compression Point (@ Output) 0.0 dBm Min.
Cross Polarization Isolation 22 dB Min.
Control Signal Ca (Vertical Polarization) 11.0 ~ 14.0 V
Control Signal Cb (Horizontal Polarization) 16.0 ~ 20.0 V
Control Signal Cc (Band Switching) 22 +/- 4 kHz
Output VSWR 2.0 : 1
In-Band Spurious – 60 dBm Max.
Current Consumption 200 mA Max. @ 11 ~ 20 V
Operating Temperature – 30 ?C ~ + 60 ?C
Output Impedance 75 ?
Output Connector F-Type (Female)
Weight 344 g
Related products
-
Read moreInverto?s high-performance Ultra LNBs were specifically designed to address the need for superior reception under the edges of the satellite footprint skirt, small dish sizes or long coax cables. Thanks to its novel feed horn design and superior front-end components, this LNB provides higher conversion gain yet with low noise figure and best phase noise performance. The combination of innovative feed horn design, higher spec components, excellent cross polarization isolation and advanced filter design enables improved handling of interfering and spurious signals. This LNB provides a leap in the overall reception performance compared with standard LNBs, enabling the reception of signals from one satellite, its distribution to two Set Top Boxes with Single Tuner (or one STB with Twin Tuner) and is ready for Ultra High Definition TV transmissions in 4K or 8K resolution. Designed to meet strict specifications and manufactured to the highest industry standards, this unique range of LNBs is an ideal solution for installations with challenging reception conditions.
Features
Novel feed horn design
Superior Phase Noise performance, DVB-S2X compliant supporting Ultra HD (4K and 8K) TV
Excellent Cross Polarization Isolation
Very Low Spurious Levels
Superior Noise Figure with high Conversion Gain
High 4G Immunity
Ultimate ReliabilityTechnical specifications
Low band input frequency range 10.7 GHz ~ 11.7 GHz
Low band output frequency range 950 MHz ~ 1950 MHz
Low band LO frequency 9.75 GHz
High band input frequency range 11.7 GHz ~ 12.75 GHz
High band output frequency range 1100 ~ 2150 MHz
High band LO frequency 10.6 GHz
Noise figure 0.6 dB typ. (1 dB Max.)
LO temperature drift ? 2.0 MHz max.
LO initial accuracy ? 1.0 MHz max.
LO phase noise @ 1 kHz -70 dBc/Hz
LO phase noise @ 10 kHz -80 dBc/Hz
LO phase noise @ 100 kHz -90 dBc/Hz
LO phase noise @ 1 MHz -100 dBc/Hz
Conversion gain 60 ~ 70 dB
Gain ripple (over 26 MHz bandwidth) 1 dB max. (peak-to-peak)
Gain variation (over full band) 4 dB max. (peak-to-peak)
Image rejection 50 dB min.
3th order intermodulation – ICP3 +10 dBm min
1 dB compression point (@ output) 0 dBm min.
Cross polarization isolation 22 dB min.
Control signal Ca (V) 10.0 V ~ 14.0 V
Control signal Cb (H) 16.0 V ~ 20.0 V
Control signal Cc (band switching) 22 kHz ? 4 kHz
Output VSWR 2.0 : 1 max.
In band spurious level -65 dBm max.
Current consumption 150 mA max. (10 VDC ~ 20 VDC)
Operating temperature -30 ?C ~ +60 ?C
Output impedance 75 ? (F-type)
Output connector type F-Type (female)
Weight 127.5 g -
Add to cartThe LNB is supplied with a 40 mm plastic ring adaptor to allow mounting onto a standard 40mm LNB holder.
Specifically designed for the European DTH markets, this Monoblock LNB allows for dual satellite reception from orbital positions 13?E and 19.2?E over a single 80cm offset satellite dish antenna with F/D = 0.6 and their distribution to up to four independent receivers.
The LNB receives satellite broadcasts with horizontal and vertical polarizations within the 10.7 ~ 12.75 GHz frequency range. It provides four universal output ports with 950 ~ 2150 MHz IF frequency range. Each output port (F-type) carries also power supply and control signals. DiSEqC 1.0 commands allow selecting the orbital satellite position. As long as no DiSEqC command has been received, the default feed is of the “Sat A” position (i.e. 13?E). Polarization (vertical/horizontal) and band (low/high) are selected using 13/18VDC and 0/22kHz control signals.
The LNB is optimized for Ultra High Definition (4K/8K) transmissions and provides excellent Cross polarization isolation, Phase Noise and Noise Figure performances. Designed to meet strict specifications and manufactured to the highest industry quality standards, this LNB is an ideal solution for satellite broadcast reception of Hotbird 13?E and Astra 19.2?E across Europe.
Features
Low Phase Noise, DVB-S2 (HDTV) compliant
Low Noise Figure
Low Power consumption
Very high Cross Polarization Isolation
Very high Frequency stabilitySpecifications
Technical specifications
Low band input frequency range 10.7 GHz ~ 11.7 GHz
Low band output frequency range 950 MHz ~ 1950 MHz
Low band LO frequency 9.75 GHz
High band input frequency range 11.7 GHz ~ 12.75 GHz
High band output frequency range 1100 MHz ~ 2150 MHz
High band LO frequency 10.6 GHz
Noise figure 0.6 dB typ., 1.0 dB max.
LO frequency accuracy @ 25? C ?0.5 MHz max.
LO temperature drift ?1 MHz max.
LO initial accuracy ?0.5 MHz max.
LO phase noise @ 1 kHz -75 dBc/Hz
LO phase noise @ 10 kHz -80 dBc/Hz
LO phase noise @ 100 kHz -90 dBc/Hz
Conversion gain 55 dB ~ 65 dB
Gain ripple (over 26 MHz bandwidth) ?0.75 dB max.
Gain variation (over full band) 6 dBpp max.
Image rejection 50 dB min.
1 dB compression point (@ output) 0 dBm min.
Cross talk 22 dB min.
Control, Satellite A/B/C/D Selection DiSEqC 1.0: Sat A* = Hotbird 13?E, Sat B = Astra 19.2?E* Default Satellite Reception
Polarity info Horizonatal polarization: 18 VDC
Vertical polarization: 13 VDC
Low band: 0 kHz
High band: 22 ?4kHz
Output VSWR 2.0 : 1 max.
In band spurious level -65 dBm max.
Current consumption 180 mA max. per port (10 VDC ~ 20 VDC)
Operating temperature -30 ?C ~ +60 ?C
Output impedance 75 ?
Output connector type F-Type (female)
Recommended Dish Size 80 cm (F/D = 0.6)
Weight 311.6 g -
Alcad UE-301 Quad lnb, universal
KSh6,412.00Add to cartAlcad UE-301 – Serie 912: Quad lnb, universal.
Universal quad LNB for offset parabolic antennas, for individual installations.
High stability in frequency and high gain. The very low noise level provides quality reception in areas of weak signal.
Downloads
Technical specification
Technical specification
Catalogues
CATALOGUE_ALCAD_EN_MULTIMEDIA_TV pdf 5.42 MB
Certificates
CE Declaration UE-301 pdf 64.45 KB
Technical specifications
-
Add to cartRange of universal LNBs low noise figure and high gain that allow capturing signals in the KU band.
-
LNB Televes single Offset Universal
KSh2,116.00Add to cartRange of universal LNBs low noise figure and high gain that allow capturing signals in the KU band.
Reviews
There are no reviews yet.